Thermal Shock Test Chamber
Product Description
Thermal Shock Test Chamber is used to test the bearing extent of the material structures and composite material in an instant and continuous high temperature and extremely low temperature environment, which is in the shortest time to test its thermal expansion and contraction caused by chemical change or physical harm.
Product Info
| Unit | USD |
|---|---|
| Minorder | 1 |
| Supplyability | 30 Set/Sets per Month |
| Port | shenzhen |
| Certification | ISO，CE |
| Place | DongGuang,China |
| Packaging | Each set protected by resin fiber and PP film, then put into Strong wooden case with operation manual and vedio inside. |
Product Detail
Application
Thermal Shock Test Chamber is used to test the bearing extent of the material structures and composite material in an instant and continuous high temperature and extremely low temperature environment, which is in the shortest time to test its thermal expansion and contraction caused by chemical change or physical harm.
Main Parameters
| Model | HD-E703-1600 (Two Zone) |
| Basket internal dimension (W*D*H) | 1300*1200*1000mm |
| External dimension(W*D*H) | 4000*2000*1900mm |
| Test method | High and Low Temp. Chamber (Two zone, basket type) |
| Thermal recovery time | Within 5 minutes |
| Lifting switch time | 7~20seconds |
| Low Temp. Test range | -10 to -40℃ |
| Pre-cool Temp. zone | Lowest temp. is -55℃ |
| High Temp. Test range | +60 to +150℃ |
| Pre-heat Temp. zone | Highest Temp. is +170℃ |
| Temperature fluctuation | ±1℃ |
| Test hole for cable routing | Diameter 100mm on the left of chamber attach a silicone plug |
| External chamber material | High quality electrolytic steel plate spray with powder, anti-rust |
| Internal material | SUS#304 stainless steel |
| Thermal insulation material | High quality superfine glass fiber |
| Refrigerant | R404A / R23 |
| Cooling method | Water cooling |
| Power supply | Three phase, 380V, 50Hz |
| Power | 120KW |
| Current | 160A |
High Temperature Chamber:
1, Including three parts: heater, draught fan and air duct valve
2, Draught fan cyclically stirs hot air through heater
3, The basket with testing product drive to high temperature range when doing high temp. impact test.
Low Temperature Chamber:
1, Including four parts: evaporator, energy storage piece, draught fan and air duct valve
2, Draught fan cyclically stirs cold air through evaporator and energy storage piece.
3, The basket with testing product drive to low temperature range when doing low temp. impact test.
Drive Device:
Pneumatic cylinder: drive basket with testing product to high and low temperature chamber
Air compressor: Provide the compressed air for driving pneumatic door (supplied by buyer)
Refrigerating Device:
Cooling system: complex overlapping efficient cryogenic loop system
Compressor: France Tecumseh compressor
Refrigerant: Environmental protection refrigerant R23/R404A
Condensation: Stainless steel welded plate heat exchanger
Safety Device:
Power overload protection
Leakage protection
Control circuit overload protection
Short-circuit protection
Compressor overload protection
Ground protection
Over temperature protection
Audible and visual alarm
Cooling Compressors